Axminster AWMS10 Manual do Utilizador descarregar pdf (Página 20)

WHITE

AXMINSTER

Setting the Laser...

www.axminster.co.uk

Aligning the Laser (Continued)

Changing the Batteries

Check that the laser line is a fine line, not dispersed or splayed. Adjust this by loosening the

screw of the holder slightly, and twist the laser to give a fine straight line;(See Fig 16)

retighten the holding screw. Loosen the two caphead bolts that secure the mounting

bracket to the frame. (See Fig 17) Move the fitting until the laser is lined up, (this can

involve a small amount of twisting) almost lined up etc. Tighten the bolts very lightly and

check again. Unfortunately, even a very small movement will move the laser line

appreciably. Tightening the bolts must be done with care and may require several attempts

to get 'right' correctly. When all is correct remove the board and any tools you have used

during the setting up procedure, reconnect the saw to the mains supply.

To adjust the laser loosen the

screw on the holder

To adjust the mounting bracket

loosen the two capheaded bolts

Fig 16

Fig 17

The unit is powered by 2 AAA cells fitted in the battery pack. To fit or change the batteries,

undo the three screws securing the lid, (See Fig 18) remove the lid, fit batteries as

required, (remembering to check the orientation of the batteries is correct); (See Figs

19,20) refit the lid to the battery pack.

Fig 18

Fig 19 Fig 20

DISCONNECT THE SAW FROM THE MAINS SUPPLY

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26 27 28

Sem comentários

Axminster AWMS10 Manual do Utilizador Página 20