Axminster SBW3501B Instruções de Operação descarregar pdf (Página 22)

Setting Up the Saw

Fig 57-58

DISCONNECT THE SAW FROM

THE MAINS SUPPLY!

Checking the table is square

Loosen the two clamping knobs beneath the

table, clamping the tilt mechanism. Lower the table

until its against the stop (19). This is a bolt with a lock

nut screwed into the underside of the table, see ﬁg 59.

The head of the bolt acts as a stop when it strikes the

machine frame. Tighten the clamping knobs.

Fig 59

Levelling stop bolt

Make sure the upper blade guide is raised as high as

possible. Place a square on the table and move it up

against the blade (behind the teeth), see ﬁg 60.

Check that the blade is perpendicular to the table. If it is

not, try resetting the table. If it is still not correct, loosen

the table locking knobs, see ﬁgs 61 and adjust the table

stop bolt nut until perpendicularity is achieved, see ﬁg 62

Fig 60

Fig 61

Fig 62

Table stop bolt

90˚ Square

Tighten the lock nut and then re-check. When you are

satisﬁed that the table is set correctly, check that the

pointer of the tilt scale reads zero, if not, adjust it, see

ﬁg 63. Retighten the table clamping knobs.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 35 36

Sem comentários

Axminster SBW3501B Instruções de Operação Página 22