Axminster AW10BSB2 Manual do Utilizador descarregar pdf (Página 18)

WHITE

AXMINSTER

www.axminster.co.uk

Mounting the Micro-Adjustor to the Rip Fence

Mounting Bracket...

Locate the Micro-Adjustor and the Rip Fence. There are two fixing screws through the

adjustor mounting bracket with square nuts on them. Ensure the nuts are undone

sufficiently to allow them to slide into the channel in the Rip Fence mounting bracket

extrusion, position as required, normally slightly to the right of the rip fence, (See fig 17) and

tighten the screws securely. Locate the capping plates for the Rip Fence Mounting Bracket

and fit carefully using the self tapping screws. Fit the Rip Fence assembly to the saw by

ensuring the clamping lug at the rear of the fence is 'hooked over' the rear rail, lower the

fence and manoeuvre the bracket over the guide rail.

Fig 17

Micro-adjuster

Fitting the micro-adjuster to the rip

fence mounting bracket

Rip fence

Mounting bracket

Mounting the Sliding Table Fence Assembly...

(See fig 18 & 19)

Locate the Main Tool Post, the Mitre Angle Rear Quadrant (and fixing bolts), the Table Fence

Mounting, the Sliding Table Fence, the Distance Stop and the workpiece Hold Down Clamp.

Take the Mitre Angle Rear Quadrant, remove the Clamping Handle and washer, put carefully

aside and bolt the quadrant on to the front edge of the Sliding Table using the bolts

provided. Introduce the Main Tool Post through the Table Fence Mounting and screw the

post into the tapped hole in the sliding table. The post is shouldered such that it holds the

Fence Mounting in position against the table.

Undo the two fence mounting bolts such that the dogs on the front surface have sufficient

movement to be able to be slid into the extrusion in the rear of the fence. Mount the Fence

such that the sacrificial plastic orange tongue is against the table to the right of the

mounting; position the fence such that when it is pivoted it will not encroach into the saw

slot. Pinch up the fixing bolts.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 47 48

Sem comentários

Axminster AW10BSB2 Manual do Utilizador Página 18