Axminster AW10BSB2 Manual do Utilizador descarregar pdf (Página 24)

WHITE

AXMINSTER

Identification & Description of the Saw Table...

www.axminster.co.uk

Saw table This is the actual machine, it comprises a cast iron table with the cut-out

(See fig A) to allow the saw blade to project through, the two slots into which the

small mitre fence can be fitted. The edges of the table have various

combinations of drilled and tapped holes to allow the mounting of the

extension tables and the fence mounting rails; the saw assembly and the

motor are bolted to the underside of the table. The saw assembly

comprises the saw shaft with its rise and fall and tilt mechanism. The

drive is provided by the motor pulley via a drive belt to the saw shaft.

The saw table is bolted into the tops of the legs of the Upper Chassis

using 4 adjustable bolts and locking nuts to enable the table to be set

correctly. The table has been factory set, and unless it is significantly

'out' should not be adjusted.

Upper chassis The Upper Chassis comprises 4 steel fabricated legs and 4 pressed

(See fig A) steel panels bolted in position between them. The two upper side

panels are mounted to the chassis frame such that they can be

removed, to allow access to the saw assembly, the motor, the drive belt

etc.; these panels are each held in position by 6 caphead bolts. The

Front panel has two cutouts for the rise and fall drive shaft and the

locking mechanism actuator to come through. The cutout for the rise

and fall shaft has a decal applied to the lower edge to enable the angle

of the saw tilt to be read off, using an index pointer mounted on the saw

mechanism.. The front right leg mounts the drive shaft for the tilt system.

The NVR ON/Off Switch plate is mounted on the upper left front leg.

Lower chassis This comprises a further 4 steel fabricated legs and 4 pressed steel

(See fig A) panels bolted in position between them. The lower rear panel has a

cutout to allow the mounting of the dust extraction moulding.

Table in sert This is a metal alloy insert that covers the hole in the saw table through

(See fig A) which the blade protrudes, and which allows access to the inside of the

saw table, to enable the riving knife to be adjusted, the saw blade to be

changed, et al. The left side of the gullet has been relieved so that the

saw blade can be tilted.

Extension tables The cast iron extension tables provide added support for the workpiece

(See fig A) beyond the boundaries of the saw table to the rip side.

Extension table Because of the weight of the extension leaves, a support leg is provided

support leg to increase stability. The height adjustment is effect by loosening the

(See fig A) caphead bolt and allowing the inner channel to slide in the outer

channel. Tighten the bolt to lock the leg at the height selected.

Rise and fall This is an engineers wheel handle attached to the shaft of the rise and

control hand fall mechanism of the saw. Turning the handle clockwise will cause the

wheel saw blade to rise , anti-clockwise to fall. Rotate control behind clockwise

(See fig A) to lock spindle.

Tilt angle A small star knob situated above the rise and fall control handle that

lock locks the tilt mechanism to prevent any movement that could be caused

(See fig A) by vibration during the saw operation.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 47 48

Comentários a estes Manuais

Sem comentários

Axminster AW10BSB2 Manual do Utilizador Página 24

Comentários a estes Manuais

Manuais e produtos relacionados com Serras circulares Axminster AW10BSB2