Axminster TSCE-12R Manual de Instruções descarregar pdf (Página 15)

Assembly

Motor Cover Assembly

˙Tool: 6mm Allen Hex Wrench

1.Remove motor cover A (Figure 1) insert on

cabinet.

2.Closing the motor cover and fasten cover

two screw A (Figure 2).

Handwheel Assembly

Referring to Figure 3:

Hardware: (2) Handle & Handwheel (C),

(2) Lock Knob (D), (2) Shaft

Key(not snown)

Tools: 3mm hex wrench

The front handwheel (E) is installed at the

factory.

Install the side handwheel (C) as follows:

1. Line up the key (taped to shaft) on the

shaft (B) with the key in the handwheel (C)

and slide the handwheel onto the shaft.

2. Tighten the set screw on the handwheel

hub (3mm hex wrench) securely to hold in

place.

3. Install the center lock knob (D) by inserting

into center hole in the shaft and threading

in a clockwise direction.

4. Install the remaining handwheel assembly

(E) in the same manner.

Miter Gauge and Fence Storage Hooks

Referring to Figure 3:

Hardware: (1) Small Hook (F)

(2) 1/4”Flat washers (J). (2)1/4”Lock

washers (H), (2) 1/4”×5/8”Socket-Head

Cap Screw (G)

Tools: 5mm hex wrench

Mount the small Hook (F) to the side of the

saw cabinet with two each 1/4”×5/8”socket-

Head Cap Screws(G), 1/4”Lock Washers (H)

and 1/4”Flat Washers (J)

FJHG

Figure 3

Figure 2

Figure 1

- 15 -

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 47 48

Comentários a estes Manuais

Sem comentários

Axminster TSCE-12R Manual de Instruções Página 15

Comentários a estes Manuais

Manuais e produtos relacionados com Serras circulares Axminster TSCE-12R

Související produkty a manuály pro Nástroje Miller-electric 402