Axminster TSCE-12R Manual de Instruções descarregar pdf (Página 4)

7. DON'T FORCE TOOL. It will do the job better and safer at the rate for which it was

designed.

8. USE RIGHT TOOL. Don't force tool or attachment to do a job for which it was not

designed.

9. The installer shall follow local regulations and National Electrical Code, ANSI/NFPA 70

installation requirements

10. WEAR PROPER APPAREL Do not wear loose clothing, gloves, neckties, rings,

bracelets, or other jewelry which may get caught in moving parts. Non-slip footwear is

recommended. Wear protective hair covering to contain long hair.

11.ALWAYS USE SAFETY GLASSES. Also use face or dust mask if cutting operation is

dusty. Everyday eyeglasses only have impact resistant lenses, they are NOT safety

glasses.

12. SECURE WORK. Use clamps or a vise to hold work when practical. It's safer than using

your hand and it frees both hands to operate tool.

13. DON'T OVERREACH. Keep proper footing and balance at all times.

14. MAINTAIN TOOLS WITH CARE. Keep tools sharp and clean for best and safest

performance. Follow instructions for lubricating and changing accessories.

15. DISCONNECT TOOLS before servicing; when changing accessories, such as blades,

bits, cutters, and the like.

16. REDUCE THE RISK OF UNINTENTIONAL STATING. Make sure switch is in off position

before plugging in.

17. USE RECOMMENDED ACCESSORIES. Consult the owner's manual for recommended

accessories. The use of improper accessories may cause risk of injury to persons.

18. NEVER STAND ON TOOL Serious injury could occur if the tool is tipped or if the cutting

tool is unintentionally contacted.

19. CHECK DAMAGED PARTS. Before further use of the tool, a guard or other part that is

damaged should be carefully checked to determine that it will operate properly and

perform its intended function - check for alignment of moving parts, binding of moving

parts, breakage of parts, mounting, and any other conditions that may affect its

operation. A guard or other part that is damaged should be properly repaired or

replaced.

20.DIRECTION OF FEED. Feed work into a blade or cutter against the direction of rotation

of the blade or cutter only.

21. NEVER LEAVE TOOL RUNNING UNATTENDED. TURN POWER OFF. Don't leave

tool until it comes to a complete stop.

GROUNDING INSTRUCTIONS：

This tool should be connected to a grounded metal permanent wiring system; or to a

system

having an equipment-grounding conductor.

- 4 -

1 2 3 4 5 6 7 8 9 ... 47 48

Sem comentários

Axminster TSCE-12R Manual de Instruções Página 4