Axminster TSCE-12R Manual de Instruções descarregar pdf (Página 17)

Riving Knife Installation

Description

Referring to Figure 7:

The complete riving knife and guard assembly

is shown in Figure.7

Installation

Referring to Figure 8:

1. Set the saw blade to the 90 degree

position and raise it all the way (refer to

Handwheel Adjustments on Figure 16.)

2. Remove the table insert (J).

3. Located inside the table and accessible

through the insert opening (Figure 8

inset), place the quick-release clamp lock

handle (K) in the unlock position.

4. The floating clamp block (L) is spring

loaded and will move away (O) from the

fixed block (M), leaving a gap.

5. Insert the bottom of the riving knife

(N1,N2) all the way into the gap between

the clamp blocks (L, M); then lock the

handle (K).

6. Replace the insert (J) back on the table.

The saw blade and riving knife should

protrude through the slot in the insert.

You should feel a snap as each piece locks in

position. Attempt to lift as a test to make sure

that they are securely locked in place.

Adjustment

The clamping blocks (L, M, Fig. 8) are

adjusted at the factory and no further

adjustment of the blade guard and riving knife

should be necessary. However, proper

alignment is very important. Before operating

the table saw, read Riving Knife Adjustment

(Page.22) to verify and follow the adjustment

procedure if necessary.

Note: please use the correct thickness of

Riving Knife to fit your blade.

N1

M

Figure 7

Figure 8

JJ

N1.

- 17 -

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 47 48

Comentários a estes Manuais

Sem comentários