Axminster C0 Instruções de Operação descarregar pdf (Página 15)

Setting Up the Saw

Checking the table is square

If the preset table stop has been ﬁtted, proceed as

follows:-

Loosen the butterﬂy nut clamping the tilt

mechanism, see ﬁg 15, and turn the table hard

against its stop. This is a bolt with a lock nut screwed

into the underside of the table, see ﬁg 16, that acts as

a stop when it strikes the machine frame. Tighten the

butterﬂy nut.

Fig 15-16

Butterﬂy nut

Make sure the upper blade guide is raised as high as

possible. Place a square on the table and move it up

against the blade (behind the teeth), see ﬁg 17.

Fig 17

Check that the blade is perpendicular to the table. If it

is not, try resetting the table.

If it is still not correct, loosen the locking nut and

adjust the bolt until perpendicularity is achieved, see

ﬁg 16. Tighten the lock nut and then re-check. When

you are satisﬁed that the table is set correctly, check

that the pointer of the tilt gauge reads zero, if not,

adjust it, see ﬁg 18.

Locking nut

Fig 18

Tilt pointer (A) and tilt gauge (B)

Setting the Fence

Always make sure the fence is parallel to the table

by placing an engineer’s rule against the fence and

setting equal distances to the front and back face of

the fence, see ﬁgs 19-20.

Continues Over...

Fig 19-20

‘T’ slot

Front face

Back face

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 27 28

Sem comentários

Axminster C0 Instruções de Operação Página 15