Axminster C0 Instruções de Operação descarregar pdf (Página 16)

Setting Up the Saw

Setting the Blade Guides

Lower the upper blade guide to approximately 1

”(38mm) above the table by loosening the blade

guide height clamp and turning the adjusting knob.

Clamp in place, see ﬁgs 21-22. Loosen the grub screw

(A) holding the guide assembly in place, see ﬁg 23.

Adjust the fore or aft position so that the leading

edges of the side guide pins are approximately 2mm

behind the gullets of the saw blade.

Re-tighten the grub screw, see ﬁgs 24-25.

Fig 21-22

Fig 23

Fig 24-25

2mm

38mm

Blade guide clamp

Adjusting knob

Blade guide

Steel rule

Guide pins

Guide assembly

Fig 26

Rear thrust bearing

Just touching the blade

Loosen the grub screw (B) that clamps the rear

thrust bearing and adjust the thrust bearing so it’s

just touching the blade; re-tighten the grub screw,

see ﬁg 26. Turn the blade by hand to check the thrust

bearing turns. Loosen the two grub screws holding

the guide pins (D), move to approximately 0.5mm

from each side of the blade. Re-tighten the grub

screws. NOTE: A ﬁve pound note is approximately

0.5mm thick, slide a note between the blade and

guide pin until the pin is set to the correct thickness.

Re-tighten the grub screws (D), see ﬁg 27. Repeat for

the other guide bush.

DISCONNECT THE SAW FROM

THE MAINS SUPPLY!

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 27 28

Sem comentários

Axminster C0 Instruções de Operação Página 16