Axminster C0 Instruções de Operação descarregar pdf (Página 7)

Assembly

Fig 02

Step 1 Locate the bandsaw table (B), the four M6

bolts (G) and shake proof washers (H). Slot the blade

into the table’s slot and line up the threaded holes

in the table with the pre-drilled holes on the tilt

quadrant, see ﬁg 02.

Step 2 Place a shake proof washer (H) over each M6

bolt (G),screw the bolts through the tilt quadrant into

the table and tighten using the supplied spanner, see

ﬁg 03.

Fig 03

Step 1 Locate the fence rail (C), fence assembly (D),

four M8 bolts (I) and washers (J). Place a washer over

the end of each bolt and lightly screw the bolts into

the threaded holes beneath the front of the table (B),

see ﬁg 04. NOTE: Leave sufﬁcient distance between

the bolt head and table for mounting the fence

rail.

Fitting the Fence

Fig 04

Step 2 Find the fence rail (C), line up the half moon

cutouts with the four bolts in the table and insert the

fence rail up against the table (B), see ﬁg 05.

Fig 05

Continues Over...

Secure the fence rail (C) in position by tightening the

four bolts with the supplied spanner, see ﬁg 06.

Fig 06

Step 3 Locate the fence assembly (D). Lower the

fence over the table until the clamping lever

assembly slots into the fence rail’s “T” slot. NOTE:

Make sure the clamping hook to the rear of

the fence (D) has engaged over the rear of the

1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

Sem comentários

Axminster C0 Instruções de Operação Página 7