Axminster Deluxe Instruções de Operação descarregar pdf (Página 10)

Assembly Instructions

two pre-drilled holes on top of the extension table, see

ﬁg 10. Lift-up the 90˚ stop located to the corners of the

extension table, push the fence up against the 90˚ stop,

see ﬁg 11 and clamp the angle bracket (A) to the table’s

steel girder by tightening the butterﬂy knob, see ﬁg 12.

Re-tighten clamping handle to lock the fence in position,

see ﬁg 10.

Fig 10

Fig 11-12

Steel pin

Pre-drilled hole

90˚ Stop

Butterﬂy

Clamping handle

Workstop Plate

Fit the workstop plate by loosening the butterﬂy nut,

insert the steel square clamp into the ‘T’ slot on the sliding

table and re-tighten the butterﬂy nut, see ﬁg 13.

Fig 13

Butterﬂy nut

Steel square clamp

Work Clamp

Locate the work clamp assembly, loosen the clamping

ring, slot the clamp assembly into the sliding table’s ‘T’

slot and tighten the ring to clamp the assembly in place.,

see ﬁg 14.

Fig 14

Clamping ring

Dust Extraction Hose

Locate the ‘Y’ rod which will support the ﬂexible hose

and screw the threaded end into one of the pre-drilled

holes on top of the planer/thicknesser chassis, see ﬁg 15.

Attach one end of the hose to the moulded outlet in the

saw guard, (make sure it is a snug ﬁt) see ﬁg 16. Attach

the other end to the dust

extraction outlet, see ﬁg

17. Lower the hose into

the ‘Y’ support rod to raise

the hose clear of the work

table, see ﬁg 18.

Fig 15

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 55 56

Sem comentários

Axminster Deluxe Instruções de Operação Página 10