Axminster Deluxe Instruções de Operação descarregar pdf (Página 14)

Assembly Instructions

Spindle Moulder

1) Remove the panel saw rip fence by lifting the locking

lever up and lifting the fence away from the guide rail,

place safely aside.

2) Disconnect the dust extraction hose from the saw

guard, remove the guard and place safely aside then

lower the saw beneath the table.

4) Remove the planer/thicknesser fence assembly by

undoing the two M6 caphead bolts on the mounting

bracket and placing the fence assembly safely aside.

5) Remove the workstop plate.

The spindle moulder guarding comes fully assembled

but is not yet mounted to the work table, see instructions

below for mounting the spindle moulder assembly.

1) Remove the circular rings from the work table and

place aside, see ﬁg 35-36-37.

NOTE: IN ORDER TO INSTALL THE SPINDLE

MOULDER ASSEMBLY THE FOLLOWING

COMPONENTS NEED TO BE REMOVED.

WARNING!! DISCONNECT THE MACHINE FROM

THE MAINS BEFORE CONTINUING!

Fig 35-36-37

Fig 38-39-40

2) Lift the spindle guard assembly onto the work table,

manoeuvre the assembly over the pre-drilled holes in the

table. Insert threaded clamping handles through the

elongated slots and align the two pre-drilled threaded

holes on either side of circular ring, see ﬁg 38.

3) Loosely screw the guard assembly down onto the table,

see ﬁg 39-40.

Pre-drilled holes

Elongated slot

Threaded clamping handle

Spindle guard assembly

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 55 56

Sem comentários

Axminster Deluxe Instruções de Operação Página 14