Axminster Deluxe Instruções de Operação descarregar pdf (Página 27)

Setting Up the Machine

Fig 50

NOTE: If you change the main blade saw blade

at anytime, the kerf width of the replacement

blade must be slightly narrower, (3.2mm) than

the kerf width of the scrolling blade.

PLEASE NOTE: If the spindle speed is set at

(3500rpm) and the tool diameter is smaller

than 120mm there is an increased risk of the

work piece kicking back at you!

With the blade assembly at 90˚degrees, turn the cap head

screw (A) one and half turns anti-clockwise. Lock the

scoring blade in position using the cap head screw (B).

Lower the saw assembly until the scoring saw is just

below the table.

Tilt the blade assembly until it reads 45˚degrees on the

tilt angle scale, check that the scoring blade is sitting just

proud of the table.

Alignment Screw

Turn the alignment screw as required to align the scoring

blade with the main blade, see ﬁ g 51.

blade is sitting just proud of the table, see ﬁ g 50.

Fig 51

Check that everything that should be tight, is tight; saw

blade guard, rise and fall lock mechanism, fence clamps

etc.

Connect the machine to the mains supply, press the

power selector switch to the ‘I’ position for spindle

moulder/panel saw, turn the selector switch to ‘2’ panel

saw (see page 21) and give the machine a quick burst. i.e.

On/Off. Check that everything is sound and feels O.K. (No

knocking, scraping, belt squeal, rubbing etc.,)

Reconnect the mains, give the machine a longer run,

and press the emergency stop button on the front of the

machine. Check that the blade comes to a complete stop.

When you are happy that everything seems OK, switch

the machine off, disconnect from the mains supply.

Blade alignment screw

WARNING!! DISCONNECT THE MACHINE FROM

THE MAINS BEFORE CONTINUING!

Spindle Moulder

Spindle Speed Setting

The spindle speed must be selected according to the

cutting diameter. The speed is set by changing the V-belt

location on the pulleys, see diagram below.

Upper location (H)....7000rpm Centre location

(M)....5500rpm Lower location (L)....3500rpm

Motor

Pulley

Spindle

Pulley

7000rpm

5500rpm

3500rpm

The cutting tool may only be changed when the spindle

rotation lock is engaged and the mains plug is pulled.

There is a risk of personal injury by cuts from the cutter

knives. Wear suitable gloves when changing cutters.

Clean all surfaces of cutters and spindle arbor with a

suitable solvent.

The Cutting Tool

Only use tooling with manual feed cutter blocks

marked “MAN”.

Continues Over....

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 55 56

Comentários a estes Manuais

Sem comentários

Axminster Deluxe Instruções de Operação Página 27

Comentários a estes Manuais

Manuais e produtos relacionados com Serras circulares Axminster Deluxe