Axminster Deluxe Instruções de Operação descarregar pdf (Página 13)

Assembly Instructions

Fig 31

Mount the overhand plane guard arm onto the side of

the out feed table that corresponds to your preferred

handing, then ﬁt the overhand cutter block guard. In the

accessories packet there is a small spring metal plate,

this ﬁts into the overhand guard clamping assembly to

spread the load of the guard clamp onto the guard. It also

prevents the bolt scoring the upper surface of the guard,

fasten in position using the guard lock,see ﬁg 33-34.

Fig 32

Caphead bolt

Mounting bracket

Clamping handles

Planer fence base

Clamp

Fence support bracket

Fig 33-34

Cutter block guard

Guard clamp

Spring metal plate

Plane guard arm

Guard arm clamp handle

Planer/Thicknesser

Locate the fence mounting bracket and ﬁx to the

machine casting as shown in ﬁg 31, using 2 No. M6 x

12mm caphead bolts, depending on your preferred

handing. Introduce the planer fence base into the

bracket; so that the planer fence base slides into the

fence mounting bracket; then secure; position the fence

approximately mid-table, see ﬁg 32.

3) Raise the saw blade to it’s highest point and slide the

fence assembly (A) up against the blade and adjust the

fence guide rail (C) until the pointer reads ‘0’on the scale

then tighten the two nuts beneath the arm rail to secure

the assembly, see ﬁg 30.

Continues Over....

Fig 30

Blade

Pointer

Scale

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 55 56

Sem comentários

Axminster Deluxe Instruções de Operação Página 13