Axminster TS-200 Instruções de Operação descarregar pdf (Página 16)

Assembly

8. Locate the rear rip fence guide rail (O), line up the

holes and the machined cutouts with the ‘T’ slots to

the rear of the saw table (A), see ﬁg 46. Insert three

cap head screws with washers through the guide rail

(O) into the threaded holes in the saw table, lightly

tighten with a Hex key. Place the further three

cap head screws with washers through the guide rail

and extension table (P), secure with the remaining

washer and nuts (Q3), see ﬁgs 47-48.

Fig 46-47-48

Hex key Machined cutout

9. Locate the extension table support leg (Q), remove

the two bolts washers and nuts and place safely

aside. Line up the holes in the support leg bracket

with the two holes to the end of the extension table

(P), replace the ﬁxing and tighten with the supplied

spanners, see ﬁg 49-50.

Fig 49-50

10. Loosen the cap head

screw on the support leg

and lower to the ﬂoor,

nip up the screw, see

ﬁg 51.

11. Place a straight edge

across both tables and

adjust the front and rear

fence rails and support

leg until the tables are

level, see ﬁg 52-53.

Fig 51

Fig 52-53

Cap head screw

Straight edge

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 43 44

Sem comentários

Axminster TS-200 Instruções de Operação Página 16