Axminster TS-200 Instruções de Operação descarregar pdf (Página 17)

Assembly

12. Replace the rip fence assembly (E) onto the

front fence rail (F). Remove the short rip fence from

the main assembly by removing the four cap head

screws, place safely aside, see ﬁg 54-55.

Fig 54-55

13. Locate the long rip fence

(N), insert the guide bearing

into the rear guide rail (O), see ﬁg 56 align the four

holes to the opposite end with the holes in the main

clamping assembly and replace the cap head screws,

securely tighten with the Hex key, see ﬁg 57.

Fig 56-57

Guide bearing

14. Move the fence (E) until it’s in line with the table’s

‘T’ slot, if the fence is out of alignment loosen the four

cap head screws on top of the rip fence assembly, see

ﬁg 57 and adjust the fence until its in alignment,

re-tighten the cap head screws.

15. Remove the rip fence extension from the short

rip fence assembly and attach it to the long rip fence

(N) as described on step 10 on page 12.

16. Slide the rip fence assembly (E) up against

the blade and check the index marker on the

magnifying glass reads ‘zero’ on the scale. If

adjustment is required loosen the ﬁxings only on

the front fence rail and lightly tap the end of the

rail until the marker reads ‘zero’ on the scale.

NOTE: PLACE A STRAIGHT EDGE

ACROSS THE FRONT EDGE OF THE

TABLES AND CHECK THEY ARE

STILL LEVEL AND ADJUST UNTIL

CORRECT.

ONLY LIGHTLY LOOSEN THE

FRONT FENCE RAIL THEN TAP

THE END UNTIL THE MARKER

READS ‘ZERO’ ON THE SCALE.

Sliding Table Kit

1. Position one carriage support arm (V) to the

underside of the cast iron saw bench (A), line up

the clearance holes (a) in the support arm with the

pre-drilled holes in the table, using four M6 x 45mm

countersink heads and nuts, (W2) secure the support

arm to the table using a 4mm Hex key (G4), see ﬁgs

58-59-60. Repeat for the remaining arm.

Continues Over...

Cap head screws

17. Replace hose support bracket (A4) to the far

corner of the extension table and hook the ﬂexible

hose over he bracket, see ﬁg 57.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 43 44

Comentários a estes Manuais

Sem comentários

Axminster TS-200 Instruções de Operação Página 17

Comentários a estes Manuais

Manuais e produtos relacionados com Ferramentas elétricas Axminster TS-200