Axminster TS-200 Instruções de Operação descarregar pdf (Página 19)

Assembly

Fig 64-65

Carriage arm rail

6. Slide the carriage table (Y) to one end of the saw

table (A), place a Level across both tables and adjust

the M6 Hex bolts (W1) until the sliding carriage table

(Y) is level with the table saw table (A), see ﬁg 66.

Repeat for the opposite side. When both tables are

level tighten the four M6 Hex nuts (W3) to secure the

sliding arm (X) in position.

Fig 66

7. Locate the two carriage arm stops (W4), loosen the

domed nuts and slide the bolt heads into each end of

the carriage arms ‘T’ slot. Tighten the nuts to lock the

stop in place, see ﬁg 67.

Fig 67

Angle Fence

1). Put to hand the work clamp block (U), and slide it

into the T-slot on the angle fence (R). Locate the

connecting block (U) and slide it onto the angle fence

as before, see ﬁgs 68-69. Slide the T-bolt on the base

of the connecting block (U) into the T-slot on the

sliding carriage table (Y), see ﬁgs 70-71. Locate the

plastic block and Phillips screws (R1), secure it to the

end of the angle fence (R), see ﬁg 72.

Fig 68-69

Work clamp block

Connecting block

‘T’ Bolt

Continues Over...

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 43 44

Sem comentários

Axminster TS-200 Instruções de Operação Página 19