Axminster TS-200 Instruções de Operação descarregar pdf (Página 20)

Assembly

Fig 70-71

Fig 72

The picture above shows the angle fence (R)

removed from the carriage table for clarity.

‘T’ Slot

‘T’ Bolt

Connecting block

2. Locate the work clamp (S), slot the work clamp into

the 20mm hole in the work clamp block (U),

secure in position with the lift and shift handle, see

ﬁg 73. To set the angle fence at 90˚, push the angle

fence (R) up against the stop, see ﬁg 74.

3. Make sure the plastic block on the end is just

missing the blade. Using a 90˚ square check that

the blade is at 90˚ to the angle fence (R), see ﬁg 75.

Lift and shift handle

Fig 73-74

Lift and shift handle

Angle fence stop

Fig 75

90˚ Square

When correct tighten the lift and shift handle on the

connecting block (U), see ﬁg 71. If the angle fence (R)

is not set to 90˚, undo the grub screw to the side of

the sliding carriage table (Y), using a ﬂat screwdriver

turn the eccentric bush until the angle is correct, see

ﬁgs 76-77.

4.To set the angle fence (R) to angles between 45˚

and 90˚ loosen the three lift and shift handles on

the connecting and work clamp blocks (U) and set

the fence to the required angle on the scale on the

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 43 44

Sem comentários

Axminster TS-200 Instruções de Operação Página 20